Stack pallets of plates in the sleek, upright design of the HydroCure Humidity Drying Chamber.

For the accelerated curing process of lead acid battery plates, you need the HydroCure Humidity Drying Chamber.

The purpose of a HydroCure Combination Humidity Drying Chamber is to dry and cure the freshly pasted plate grid. Pallets of plates are stacked in the sleek, upright design of the HydroCure Humidity Drying Chamber easily.  A proprietary High Velocity Nozzle integral design in the supply duct ensures proper crystal growth.

There are many challenges in operating a battery production line efficiently. Proper utilization of the curing chambers’ design and size can be a challenge. If the chamber design is under-sized, the production rate will fall short. If the curing chamber is over-sized, excessive curing time cycles will occur. An under-sized or over-sized chamber causes a bottleneck in production rates.

We engineer solutions to address battery production line challenges. The HydroCure Humidity Drying Chamber optimizes production volume while decreasing excessive curing cycles.

Try the NEW Laboratory HydroCure Humidity Drying Chamber

Are you looking to fine tune your curing and drying process?  Do you need to create a new profile for a new product? Then the Laboratory HydroCure Humidity Drying Chamber is the chamber for you.

The new Laboratory HydroCure Humidity Drying Chamber is available in a 2ft x 2ft x 2ft (610mm x 610mm x 610mm) chamber size. The Laboratory HydroCure Humidity Drying Chamber offers all the features of the larger standard chambers. You can be confident your profile will migrate seamlessly to the plant floor.

The Laboratory HydroCure Humidity Drying Chamber is PLC controlled with an easy-to-use operator interface. Use a USB Card to create and load up to twenty custom profiles. Trending in real time appears on the operator interface screen.